Gap detection for moulding press
Use a separate heat-resistant sensor head to detect unwanted objects which remained in the moulding press.
|
|
Challenge
If unwanted objects remain in the moulding press the upper mould does not come down to its proper position and causes defective products. The bottom position of the upper mould has to be checked at four corners.
|
Solution
A separate heat-resistant sensor head can be attached near to the hot mould to check the mould position accurately. A separate digital amplifier enables easy set up and operation.
|
Benefit
Yield improvement through failure-rate reduction and a solution that is economic, easy to implement and saves setting-up costs and time.
|
|
